Mitsubishi Electric MELSEC iQ-R Series - Converting the Edge Relay Operation Result into a Pulse

5 SEQUENCE INSTRUCTIONS
5.2 Association Instructions
173
5
Converting the edge relay operation result into a pulse
EGP, EGF
• EGP: Converting the edge relay operation result into a pulse (rising edge)
This instruction stores the operation result up to the EGP instruction in the edge relay (V). The instruction turns on at the rising
edge (off to on) of the operation result.
• EGF: Converting the edge relay operation result into a pulse (falling edge)
This instruction stores the operation result up to the EGF instruction in the edge relay (V). The instruction turns on at the
falling edge (on to off) of the operation result.
■Execution condition
Setting data
■Description, range, data type
*1 Only bit type labels assigned to the device (V) can be used.
■Applicable devices
Ladder ST
ENO:=EGP(EN,d);
ENO:=EGF(EN,d);
FBD/LD
Instruction Execution condition
EGP
EGF
Operand Description Range Data type Data type (label)
(d) Edge relay number for storing operation result  Bit ANY_BOOL
*1
EN Execution condition  Bit BOOL
ENO Execution result  Bit BOOL
Operand Bit Word Double word Indirect
specification
Constant Others
(V)
X, Y, M, L,
SM, F, B, SB,
FX, FY
J\ T, ST, C, D, W,
SD, SW, FD, R,
ZR, RD
U\G, J\,
U3E\(H)G
Z LT, LS T,
LC
LZ K, H E $
(d) 
RnCPU
RnENCPU
RnSFCPU RnSFCPURnPCPURnPCPU
(Standard) (Safety)
(Redundant) (Process)
EGP
EGF
(d)
(d)
EN ENO
d