1068
7 APPLICATION INSTRUCTIONS
7.27 Module Access Instructions
• These instructions read the module information by the number of points specified by (n) from the module specified by (H),
and store the information in the device areas specified by (d) and later. Even if the module type or the number of points is
changed in I/O assignment, the status of the mounted module is read.
• For (H), specify the start I/O number of the module, whose information is to be read, with upper 3 digits when it is
represented by 4 hexadecimal digits.
• If an I/O number other than the start I/O number of the read target module is specified, module information in which only the
module mount status is on and any other status is off is stored.
(1) Specify K4 or H4 as the start I/O number of the read-target module.
RX10 RX10RX10
RJ71EN71
RX10CPU RX10
0000H 0010H 0020H 0030H 0040H 0060H
PW
(1)
To Next Page
Loading...
