Mitsubishi Electric MELSEC iQ-R Series - Page 109

2 CPU MODULE INSTRUCTIONS
2.3 Application Instructions
107
2
■Zone control of 16-bit/32-bit binary data
■Scaling 16-bit/32-bit binary data (point coordinates)
■Scaling 16-bit/32-bit binary data (XY coordinates)
Special counter instructions
■Counting up or down the current value (1-phase input)
■Counting up or down the current value (2-phase input)
Instruction symbol Processing details Reference
ZONE Adds a bias value to the specified input value (16-bit binary). Page 865
ZONE(P)(_U)
ZONEP
ZONE_U
ZONEP_U
DZONE Adds a bias value to the specified input value (32-bit binary). Page 867
DZONE(P)(_U)
DZONEP
DZONE_U
DZONEP_U
Instruction symbol Processing details Reference
SCL Scales the scaling conversion data (16-bit data) in the device specified by (s2) on the basis of the
input value in the device specified by (s1), and stores the operation result in the device specified by
(d).
Scaling conversion is performed based on the scaling conversion data stored in the device
specified by (s2) and later.
Page 869 SCL(P)(_U)
SCLP
SCL_U
SCLP_U
DSCL Scales the scaling conversion data (32-bit data) in the device specified by (s2) on the basis of the
input value in the device specified by (s1), and stores the operation result in the device specified by
(d).
Scaling conversion is performed based on the scaling conversion data stored in the device
specified by (s2) and later.
Page 872
DSCL(P)(_U)
DSCLP
DSCL_U
DSCLP_U
Instruction symbol Processing details Reference
SCL2 Scales the scaling conversion data (16-bit data) in the device specified by (s2) on the basis of the
input value in the device specified by (s1), and stores the operation result in the device specified by
(d).
Scaling conversion is performed based on the scaling conversion data stored in the device
specified by (s2) and later.
Page 875 SCL2(P)(_U)
SCL2P
SCL2_U
SCL2P_U
DSCL2 Scales the scaling conversion data (32-bit data) in the device specified by (s2) on the basis of the
input value in the device specified by (s1), and stores the operation result in the device specified by
(d).
Scaling conversion is performed based on the scaling conversion data stored in the device
specified by (s2) and later.
Page 877
DSCL2(P)(_U)
DSCL2P
DSCL2_U
DSCL2P_U
Instruction symbol Processing details Reference
UDCNT1 Updates the current value of the specified counter.
(1) Current value of Cn
(2) Contact of Cn
Page 879 UDCNT1
Instruction symbol Processing details Reference
UDCNT2 Updates the current value of the counter depending on the status of phases A and B pulses.
(1) Current value of Cn
(2) Contact of Cn
Page 881 UDCNT2
(s1)
(s1)+1
0 2 3 4 6 7 6 5 3 2 1 0 -1-2 -3 -2 -1 01 54
(1)
(2)
Up Up
Down
(s1)
(s1)+1
12 4543 10-10 3 2
(1)
(2)