Mitsubishi Electric MELSEC iQ-R Series - Page 1388

1386
11 PROCESS CONTROL INSTRUCTIONS
11.6 Comparison Operation Instructions
S.>=
This instruction compares input data, and outputs the comparison result.
■Execution condition
Setting data
■Description, range, data type
■Applicable devices
■Input data
Ladder ST
ENO:=S_GE(EN,s1,s2,s3,d1);
FBD/LD
( is to be replaced by S_GE.)
Instruction Execution condition
S.>=
Operand Description Range Data type
(s1) Input data start device Refer to "Input data". Word
(d1) Block memory start device Refer to "Block memory". Word
(s2) Operation constant start device Refer to "Operation constant". Word
(s3) Empty string specification
(Specify "" in ladder. Specify '' in ST or FBD/LD.)
 String
EN Execution condition  Bit
ENO Execution result  Bit
Operand Bit Word Double word Indirect
specification
Constant Others
X, Y, M, L,
SM, F, B, SB,
FX, FY
J\ T, ST, C, D, W,
SD, SW, R, ZR,
RD
U\G, J\,
U3E\(H)G
Z LT, LST,
LC
LZ K, H E $
(s1)         
(d1)         
(s2)         
(s3)   
Operand: (s1)
Device Symbol Name Recommended range Data type Standard
value
Set by
+0
+1
E1 Input value 1 -999999 to 999999 Single-precision
real number
 User
+2
+3
E2 Input value 2 -999999 to 999999 Single-precision
real number
 User
RnCPU
RnENCPU
RnSFCPU RnSFCPURnPCPURnPCPU
(Standard) (Safety)
(Redundant) (Process)
(s1) (d1) (s2) (s3)
EN ENO
d1s1
s2
s3