190
5 SEQUENCE INSTRUCTIONS
5.3 Output Instructions
• This instruction changes the device status as follows when the execution command turns on.
• The device that has been turned on remains on even after the execution command turns off. The device that has been
turned on can be turned off by using the RST instruction.
• When the execution command is off, the device status does not change.
There is no operation error.
When X is used, specify a device number that is not used in actual input. If the number that is used in actual
input is specified, the data of actual input is written over the input device (X) specified by the SET instruction.
Device Status
Bit device Turns on the coil or contact.
Bit-specified word device Sets the specified bit to 1.
SET Y10
RST Y10
X5
X7
X5 OFF
X7 OFF
Y10 OFF
ON
ON
ON
To Next Page
Loading...
