Mitsubishi Electric MELSEC iQ-R Series - Page 395

6 BASIC INSTRUCTIONS
6.6 Data Conversion Instructions
393
6
Processing details
• These instructions convert the single-precision real number in the device specified by (s) to 32-bit unsigned binary data,
and store the converted data in the device specified by (d).
• After conversion, the first digit after the decimal point of the single-precision real number is rounded off.
• When an input value is set using the engineering tool, a rounding error may occur. For the precautions on setting an input
value using the engineering tool, refer to the following.
Page 49 Precautions
The following program example converts, when M0 turns on, the single-precision real number stored in D0 and D1 to 32-bit
unsigned binary data, and stores the converted data in D100 and D101.
Operation error
Error code
(SD0)
Description
3401H The single-precision real number in the device specified by (s) is out of the range, 0 to 4294967295.
3402H An unusual number is set to (s).
• The single-precision real number set to (s) is not within the following range:
0, 2
-126
|(s)|<2
128
• The value set to a device or label is -0, a subnormal number, NaN (not a number), or .
(d)
(s)
b31 b16
(123456.7)
205AH
47F1H
b15 b0
D1, D0
b31 b16
(123457)
E241H
0001H
b15 b0
D101, D100
   
SM402
(s)
(d)
M0
EMOVP E123456.7 D0
FLT2UDINT D0 D100