Mitsubishi Electric MELSEC iQ-R Series - Page 48

46
1 OVERVIEW
1.2 Data Specification Method
Digit specification range
The following table lists the range of 32-bit data for each digit specification.
Ex.
When digit specification is made for X0, the applicable number of points is as follows.
•K1X04 points from X0 to X3
•K2X08 points from X0 to X7
•K3X012 points from X0 to XB
•K4X016 points from X0 to XF
•K5X020 points from X0 to X13
•K6X024 points from X0 to X17
•K7X028 points from X0 to X1B
•K8X032 points from X0 to X1F
Digit
specification
Decimal notation Hexadecimal notation
K1 0 to 15 0H to FH
K2 0 to 255 00H to FFH
K3 0 to 4095 000H to FFFH
K4 0 to 65535 0000H to FFFFH
K5 0 to 1048575 00000H to FFFFFH
K6 0 to 16777215 000000H to FFFFFFH
K7 0 to 268435455 0000000H to FFFFFFFH
K8 Signed 32-bit data: -2147483648 to 2147483647
Unsigned 32-bit data: 0 to 4294967295
00000000H to FFFFFFFFH
X1F X1C X1B X18X17 X14X13 X10 XF XCXB X8X7 X4 X3 X0
· · · · · · · ·
K2X0
K1X0
K3X0
K4X0
K5X0
K6X0
K7X0
K8X0