Mitsubishi Electric MELSEC iQ-R Series - Page 729

7 APPLICATION INSTRUCTIONS
7.9 Real Number Instructions
727
7
ED+(P) [when three operands are set]
These instructions add double-precision real numbers.
■Execution condition
Setting data
■Description, range, data type
■Applicable devices
Ladder ST
ENO:=EDPLUS(EN,s1,s2,d);
ENO:=EDPLUSP(EN,s1,s2,d);
FBD/LD
( is replaced by either of the following: EDPLUS, EDPLUSP.)
Instruction Execution condition
ED+
ED+P
Operand Description Range Data type Data type (label)
(s1) First addend data or the start device where the first addend
data is stored
0, 2
-1022
|(s1)|<2
1024
Double-precision real
number
ANYREAL_64
(s2) Second addend data or the start device where the second
addend data is stored
0, 2
-1022
|(s2)|<2
1024
Double-precision real
number
ANYREAL_64
(d) Start device for storing the operation result  Double-precision real
number
ANYREAL_64
EN Execution condition  Bit BOOL
ENO Execution result  Bit BOOL
Operand Bit Word Double word Indirect
specification
Constant Others
X, Y, M, L,
SM, F, B, SB,
FX, FY
J\ T, ST, C, D, W,
SD, SW, FD, R,
ZR, RD
U\G, J\,
U3E\(H)G
Z LT, LST,
LC
LZ K, H E $
(s1)   
(s2)   
(d)         
RnCPU
RnENCPU
RnSFCPU RnSFCPURnPCPURnPCPU
(Standard) (Safety)
(Redundant) (Process)
(s1) (s2) (d)
EN ENO
ds1
s2