Mitsubishi Electric MELSEC iQ-R Series - Page 778

776
7 APPLICATION INSTRUCTIONS
7.9 Real Number Instructions
Processing details
• These instructions calculate the tangent of the angle specified by (s), and store the operation result in the device specified
by (d).
• Set the angle data in radians (angle180).
• If the operation result is -0 or an underflow occurs, the operation result turns out to 0.
• When an input value is set using the engineering tool, a rounding error may occur. Refer to the following for the precautions
on setting input values using the engineering tool.
Page 49 Precautions
Precautions
If the angle specified by (s) is /2 radian or (3/2) radian, no operation error will be issued because of the truncation error in
the radian value.
Operation error
For the angleradian conversion, refer to the RAD(P) and DEG(P) instructions.
Page 807 RAD(P)
Page 809 DEG(P)
Error code
(SD0)
Description
3402H The value input to (s) is -0, a subnormal number, NaN (not a number), or .
(s)+1 (s) (d)+1 (d)
TAN ( )
Single-precision real number Single-precision real number