Mitsubishi Electric MELSEC iQ-R Series - Page 780

778
7 APPLICATION INSTRUCTIONS
7.9 Real Number Instructions
Processing details
• These instructions calculate the angle based on the sine data in the device specified by (s), and store the operation result
in the device number specified by (d).
• The sine data in the device specified by (s) can be set in the range from -1.0 to 1.0.
• The angle (operation result) is stored in radians in the device specified by (d).
• If the operation result is -0 or an underflow occurs, the operation result turns out to 0.
• When an input value is set using the engineering tool, a rounding error may occur. Refer to the following for the precautions
on setting input values using the engineering tool.
Page 49 Precautions
Operation error
For the angleradian conversion, refer to the RAD(P) and DEG(P) instructions.
Page 807 RAD(P)
Page 809 DEG(P)
Error code
(SD0)
Description
3402H The value input to (s) is -0, a subnormal number, NaN (not a number), or .
3405H The value in the device specified by (s) is out of the range, -1.0 to 1.0.
(s)+1 (s) (d)+1 (d)
SIN
-1
( )
Single-precision real number Single-precision real number