810
7 APPLICATION INSTRUCTIONS
7.9 Real Number Instructions
• These instructions convert the unit of the measure of angle from the radian specified by (s) to the degree, and store the
angle in degrees in the device number specified by (d).
• Unit conversion from the radian to the degree is performed as follows.
• When an input value is set using the engineering tool, a rounding error may occur. Refer to the following for the precautions
on setting input values using the engineering tool.
Page 49 Precautions
Error code
(SD0)
Description
3402H The value input to (s) is -0, a subnormal number, NaN (not a number), or .
3403H The data output from (d) exceeds the following range. (An overflow has occurred.)
|(d)|<2
128
(s)+1 (s) (d)+1 (d)
( )°( ) rad
Single-precision real number Single-precision real number
To Next Page
Loading...
