Mitsubishi Electric MELSEC iQ-R Series - Page 834

832
7 APPLICATION INSTRUCTIONS
7.9 Real Number Instructions
Processing details
• These instructions raises the single-precision real number specified by (s1) to the power of the single-precision real number
specified by (s2), and store the operation result in the device specified by (d).
• The values that can be specified by (s1) and (s2) and the value that can be stored are 0, 2
-126
|setting value (stored
value)|<2
128
.
• If the operation result is -0 or an underflow occurs, the operation result turns out to 0.
• When an input value is set using the engineering tool, a rounding error may occur. Refer to the following for the precautions
on setting input values using the engineering tool.
Page 49 Precautions
Operation error
Error code
(SD0)
Description
3402H The value input to (s1) or (s2) is -0, a subnormal number, NaN (not a number), or .
(s2)+1 (s2)
(s1)+1 (s1)
(s1)+1 (s1)
(d)+1 (d)
Single-precision
real number
Single-precision
real number
Base number
Exponent
to the th power
(s2)+1 (s2)