NETGEAR M4200

OSPF
133
Managed Switches
A screen similar to the following displays.
b. Scroll down and select the interface 1/0/15 check box. Now 1/0/15 appears in the
Interface field at the top.
c. Enter the following information:
• In the OSPF Area ID field, enter 0.0.0.1.
• In the OSPF Admin Mode field, select Enable.
d. Click Apply to save the settings.
7. Configure area 0.0.0.1 as an NSSA area.
a. Select Routing > OSPF > Advanced > NSSA Area Configuration.
A screen similar to the following displays.
b. In the Area ID field, enter 0.0.0.1.
c. Click Add to save the settings.
8. Redistribute the RIP routes into the OSPF area.
a. Select Routing > OSPF > Advanced > Route Redistribution.