Security Management
324
Managed Switches
b. In the VLAN ID field, enter 2000.
c. In the VLAN Type field, select Static.
d. Click Add.
2. Add ports to VLAN 2000.
a. Select Switching > VLAN > Advanced > VLAN Membership.
A screen similar to the following displays.
b. In the VLAN ID list, select 2000.
c. Click Unit 1. The ports display.
d. Click the gray boxes under ports 1 and 24 until U displays.
The U specifies that the egress packet is untagged for the port.
e. Click Apply.
3. Set force authorized mode on ports 1/0/6 and 1/0/12.
a. Select Security > Port Authentication > Advanced > Port Authentication.
A screen similar to the following displays.
b. Scroll down and select the Interface 1/0/6 and 1/0/12, check boxes.
c. In the Control Mode list, select Force Authorized.
d. Click Apply to save settings.
4. Enable dot1x on the switch.
Make sure that 1/0/12 and 1/0/6 are configured as force authorized before you do this
step; otherwise you cannot access the switch through the Web Interface.
a. Select Security > Port Authentication > Basic > 802.1x Configuration.
To Next Page
Loading...
