NETGEAR M4200 - Page 357

Security Management
357
Managed Switches
2. Change the authentication mode for Telnet users to RADIUS.
3. Verify that RADIUS authentication is set up for Telnet users.
4. Create a command authorization list and configure RADIUS as the authorization.
5. Configure command authorization list for Telnet.
(Netgear Switch)(Config)#aaa authentication login networkList radius
(Netgear Switch) #show authentication methods
Login Authentication Method Lists
---------------------------------
defaultList : local
networkList : radius
Enable Authentication Method Lists
----------------------------------
enableList : enable none
enableNetList : enable none
Line Login Method List Enable Method List
------- ----------------- ------------------
Console defaultList enableList
Telnet networkList enableList
SSH networkList enableList
HTTPS :local
HTTP :local
DOT1X :
(Netgear Switch)(Config)# aaa authorization commands commandList radius
Netgear Switch) (Config)#line telnet
(Netgear Switch) (Config-telnet)#authorization commands commandList
(Netgear Switch) (Config-telnet)#exit