NETGEAR M4200

Security Management
360
Managed Switches
2. Verify that TACACS authentication is set up for Telnet users.
3. Create an EXEC authorization list and configure TACACS as the authorization.
4. Configure EXEC authorization for Telnet.
(Netgear Switch) #show authentication methods
Login Authentication Method Lists
---------------------------------
defaultList : local
networkList : tacacs
Enable Authentication Method Lists
----------------------------------
enableList : enable none
enableNetList : enable none
Line Login Method List Enable Method List
------- ----------------- ------------------
Console defaultList enableList
Telnet networkList enableList
SSH networkList enableList
HTTPS :local
HTTP :local
DOT1X :
(Netgear Switch)(Config)#aaa authorization exec "execList" tacacs
(Netgear Switch)(Config)#line telnet
(Netgear Switch)(Config-telnet)#authorization exec execList
(Netgear Switch)(Config-telnet)#exit