SNTP
395
Managed Switches
2. After configuring the IP address, enable SNTP client mode.
The client mode can be either broadcast mode or unicast mode. If the NTP server is not
your own, you must use unicast mode.
When the SNTP client mode is enabled, the client waits for the polling interval to send the
query to the server. The default value is approximately 1 minute.
3. After this period, issue the show command to confirm that the time was received.
The time will be used in all logging messages.
(Netgear Switch) (Config)#sntp client mode unicast
(Netgear Switch) #show sntp server
Server IP Address: 208.14.208.19
Server Type: ipv4
Server Stratum: 4
Server Reference Id: NTP Srv: 208.14.208.3
Server Mode: Server
Server Maximum Entries: 3
Server Current Entries: 1
SNTP Servers
------------
IP Address: 208.14.208.19
Address Type: IPV4
Priority: 1
Version: 4
Port: 123
Last Update Time: Mar 26 03:36:09 2006
Last Attempt Time: Mar 26 03:36:09 2006
Last Update Status: Success
Total Unicast Requests: 2
Failed Unicast Requests: 0
To Next Page
Loading...
