VLANs
50
Managed Switches
T specifies that the switch tags egress packets for port 24.
d. Click Apply.
3. Enable GVRP globally:
a. Select Switching > VLAN > Advanced > GARP Switch Configuration.
A screen similar to the following displays.
b. Next to GVRP Mode, select the Enable radio button.
c. Click Apply.
4. Enable GVRP on port 1/0/24.
a. Select Switching > VLAN > Advanced > GARP Port Configuration.
A screen similar to the following displays.
b. Scroll down and select the check box that corresponds to interface 1/0/24.
The Interface field in the table heading displays 1/0/24.
To Next Page
Loading...
