NETGEAR M4200 - Page 531

Tunnels for IPv6
531
Managed Switches
3. Create a routing interface and assign an IP address to it.
a. Select Routing > IP > Advanced > IP Interface Configuration.
A screen similar to the following displays.
b. Select the 1/0/1 check box for port 1/0/1.
The settings for port 1/0/1 display in the fields in the table heading.
c. Configure the following settings:
• In the IP Address Configuration Method field, select Manual.
• In the IP Address field, enter 195.1.3.2.
• In the Subnet Mask field, enter 255.255.255.0.
• In the Routing Mode field, select Enable.
d. Click Apply.
4. Create an IPv6 routing interface.
a. Select Routing > IPv6 > Advanced > Interface Configuration.
A screen similar to the following displays.
b. Select the 1/0/3 check box for port 1/0/3.