NETGEAR M4200 - Page 561

PIM
561
Managed Switches
2. Enable IGMP on port 1/0/24.
3. PIM-DM builds the multicast routes table on each switch.
(Netgear Switch) (Config)#interface 1/0/24
(Netgear Switch) (Interface 1/0/24)#routing
(Netgear Switch) (Interface 1/0/24)#ip pim
(Netgear Switch) (Interface 1/0/24)#ip igmp
(Netgear Switch) (Interface 1/0/24)#ip rip
(Netgear Switch) (Interface 1/0/24)#ip address 192.168.4.1 255.255.255.0
(Netgear Switch) (Interface 1/0/24)#exit
(A) #show ip mcast mroute summary
Multicast Route Table Summary
Incoming Outgoing
Source IP Group IP Protocol Interface Interface List
----------- ---------- ---------- --------- ---------------
192.168.1.1 225.1.1.1 PIMDM 1/0/13 1/0/1
(B) #show ip mcast mroute summary
Multicast Route Table Summary
Incoming Outgoing
Source IP Group IP Protocol Interface Interface List
----------- --------- ---------- --------- ---------------
192.168.1.1 225.1.1.1 PIMDM 1/0/10
(C) #show ip mcast mroute summary
Multicast Route Table Summary
Incoming Outgoing
Source IP Group IP Protocol Interface Interface List
----------- --------- -------- --------- ---------------
192.168.1.1 225.1.1.1 PIMDM 1/0/21
(D) #show ip mcast mroute summary
Multicast Route Table Summary
Incoming Outgoing
Source IP Group IP Protocol Interface Interface List
---------- --------- -------- ---------- ---------------
192.168.1.1 225.1.1.1 PIMDM 7/0/21 7/0/24