NETGEAR M4200 - Page 591

PIM
591
Managed Switches
b. For PIM Protocol Type, select the PIM-SM radio button.
c. For Admin Mode, select the Enable radio button.
d. Click Apply.
8. Enable PIM-SM on interfaces 1/0/10 and 1/0/11.
a. Select Routing > Multicast > PIM > Interface Configuration.
A screen similar to the following displays.
b. Scroll down and select the Interface 1/0/10 and 1/0/11 check boxes.
c. In the Admin Mode field, select Enable.
d. Click Apply to save the settings.
9. Set up the candidate RP configuration.
a. Select Routing > Multicast > PIM > Candidate RP Configuration.
A screen similar to the following displays.
b. In the Interface list, select 1/0/11.
c. In the Group IP field, enter 225.1.1.1.
d. In the Group Mask field, enter 255.255.255.0.
e. Click Add.
10. Set up the BSR candidate configuration.
a. Select Routing > Multicast > PIM > BSR Candidate Configuration.