Configuring Spanning Tree Parameters Configuring STP Port Parameters
OmniSwitch AOS Release 7 Network Configuration Guide June 2013 page 6-39
To change the path cost value for a link aggregate, use the spantree cist path cost, spantree msti path
cost, or spantree vlan path cost command with the linkagg parameter and a link aggregate control (ID)
number. For example, the following command sets the path cost for link aggregate 10 associated with
VLAN 755 to 19:
-> spantree vlan 755 linkagg 10 path-cost 19
For more information about configuring an aggregate of ports, see Chapter 7, “Configuring Static Link
Aggregation,” and Chapter 8, “Configuring Dynamic Link Aggregation.”
830
100 Mbps 2 12
49
87
1 Gbps N/A 3
10 Gbps N/A 1
Link Speed
Aggregate Size
(number of links)
Default Path
Cost Value
To Next Page
Loading...
Need help?
General