Configuring VRRP VRRP Specifications
OmniSwitch AOS Release 7 Network Configuration Guide June 2013 page 22-3
VRRP Specifications
VRRP Defaults
The following table lists the defaults for VRRP configuration through the vrrp command and the relevant
command keywords:
The following table lists the defaults for VRRP configuration using the VRRP collective management
features and the relevant command:
Platforms Supported OmniSwitch 10K, 6900
RFCs Supported RFC 3768–Virtual Router Redundancy Protocol
RFC 2787–Definitions of Managed Objects for the Virtual
Router Redundancy Protocol
Compatible with HSRP No
Maximum number of VRRPv2 and VRRPv3
virtual routers
255
Maximum number of IP addresses per
instance
16
Description Keyword Default
Virtual router enabled or dis-
abled
enable | disable Virtual routers are disabled
Priority priority 100
Preempt mode preempt | no preempt Preempt mode is enabled
Advertising interval advertising interval 1 second (100 centiseconds)
Default advertising interval for
all the virtual routers on the
switch.
vrrp interval 1 second (100 centiseconds)
Default priority value for all the
virtual routers on the switch.
vrrp priority 100
Default preempt mode for all the
virtual routers on the switch.
vrrp preempt preempt
Parameter value that is to be set
and/or override with the new
default value in all the virtual
routers on the switch.
vrrp set all
Default advertising interval for
all the virtual routers in the
group.
vrrp group 1
Default priority value for all the
virtual routers in the group.
vrrp group 100
To Next Page
Loading...
Need help?
General