Diagnosing Switch Problems Monitoring Switch Health
OmniSwitch AOS Release 7 Network Configuration Guide June 2013 page 32-47
Viewing Health Statistics for a Specific Interface
To view health statistics for slot 4/port 3, enter the show health command, followed by the appropriate
slot and port numbers. A screen similar to the following example is displayed, as shown below:
-> show health port 4/3
* - current value exceeds threshold
Port 04/03 1 Min 1 Hr 1 Hr
Resources Limit Curr Avg Avg Max
------------------+----------+--------+--------+---------+--------------------
Receive 80 01 01 01 01
Transmit/Receive 80 01 01 01 01
In the screen sample shown above, the port 04/03 Resources field displays the port resources that are
being measured (for example, Receive displays statistics for traffic received by the switch, while Trans-
mit/Receive displays statistics for traffic transmitted and received by the switch). The Limit field displays
currently configured resource threshold levels as percentages of available bandwidth. The Curr field
displays current bandwidth usage for the specified resource. 1 Min. Avg. refers to the average resource
bandwidth used over a 1 minute period. 1 Hr. Avg. refers to the average resource bandwidth used over a 1
hour period, and 1 Hr. Max. refers to the maximum resource bandwidth used over a 1 hour period.
To Next Page
Loading...
Need help?
General