Modifying IPMSv6 Parameters Configuring IP Multicast Switching
page 24-34 OmniSwitch AOS Release 7 Network Configuration Guide June 2013
Or, as an alternative, enter:
-> ipv6 multicast vlan 2 robustness
To restore the MLD robustness to its default value.
Enabling and Disabling the MLD Spoofing
By default, MLD spoofing (i.e., replacing a client's MAC and IPv6 address with the system's MAC and
IPv6 address, when proxying aggregated MLD group membership information) is disabled on the switch.
The following subsections describe how to enable and disable spoofing by using the ipv6 multicast spoof-
ing command.
Enabling the MLD Spoofing
To enable MLD spoofing on the system if no VLAN is specified, you use the ipv6 multicast spoofing
command as shown below:
-> ipv6 multicast spoofing enable
You can also enable MLD spoofing on the specified VLAN by entering:
-> ipv6 multicast vlan 2 spoofing enable
Disabling the MLD Spoofing
To disable MLD spoofing on the system if no VLAN is specified, you use the ipv6 multicast spoofing
command as shown below:
-> ipv6 multicast spoofing disable
Or, as an alternative, enter:
-> ipv6 multicast spoofing
To restore the MLD spoofing to its default setting.
You can also disable MLD spoofing on the specified VLAN by entering:
-> ipv6 multicast vlan 2 spoofing disable
Or, as an alternative, enter:
-> ipv6 multicast vlan 2 spoofing
To restore the MLD spoofing to its default setting.
You can remove an MLD spoofing entry on the specified VLAN and return to its default behavior by
entering:
-> no ipv6 multicast vlan 2 spoofing
Enabling and Disabling the MLD Zapping
By default MLD (i.e., processing membership and source filter removals immediately without waiting for
the specified time period for the protocol– this mode facilitates IP TV applications looking for quick
To Next Page
Loading...
Need help?
General