Remote Monitoring (RMON) Diagnosing Switch Problems
page 32-38 OmniSwitch AOS Release 7 Network Configuration Guide June 2013
Displaying Statistics for a Particular RMON Probe
To view statistics for a particular current RMON probe, enter the show rmon probes command,
specifying an entry number for a particular probe, such as:
-> show rmon probes 4005
A display showing statistics for the specified RMON probe appears, as shown in the following sections.
Sample Display for Ethernet Statistics Probe
The display shown here identifies RMON Probe 4005’s Owner description and interface location
(OmniSwitch Auto Probe on slot 4, port 5), Entry number (4005), probe Flavor (Ethernet statistics), and
Status (Active). Additionally, the display indicates the amount of time that has elapsed since the last
change in status (48 hours, 54 minutes), and the amount of memory allocated to the probe, measured in
bytes (275).
-> show rmon probes 4005
Probe’s Owner: Switch Auto Probe on Slot 4, Port 5
Entry 4005
Flavor = Ethernet, Status = Active
Time = 48 hrs 54 mins,
System Resources (bytes) = 275
To Next Page
Loading...
Need help?
General