EasyManuals Logo

OmniSwitch os6900 User Manual

Default Icon
942 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #174 background imageLoading...
Page #174 background image
Configuring Dynamic Link Aggregate Groups Configuring Dynamic Link Aggregation
page 8-8 OmniSwitch AOS Release 7 Network Configuration Guide June 2013
Relationship to Other Features
Link aggregation groups are supported by other switch software features. For example, you can configure
802.1Q tagging on link aggregation groups in addition to configuring it on individual ports. The following
features have CLI commands or command parameters that support link aggregation:
VLANs. For more information on VLANs, see Chapter 4, “Configuring VLANs.”
802.1Q. For more information on configuring and monitoring 802.1Q, see Chapter 4, “Configuring
VLANs.”
Spanning Tree. For more information on Spanning Tree, see Chapter 6, “Configuring Spanning Tree
Parameters.”
Note. See “Application Examples” on page 8-27 for tutorials on using link aggregation with other features.
Configuring Dynamic Link Aggregate Groups
This section describes how to use Alcatel-Lucent’s Command Line Interface (CLI) commands to create,
modify, and delete dynamic aggregate groups. See “Configuring Mandatory Dynamic Link Aggregate
Parameters” on page 8-9 for more information.
Note. See “Quick Steps for Configuring Dynamic Link Aggregation” on page 8-4 for a brief tutorial on
configuring these mandatory parameters.
Alcatel-Lucent’s link aggregation software is preconfigured with the default values for dynamic aggregate
groups and ports shown in the table in “Dynamic Link Aggregation Default Values” on page 8-3. For most
configurations, using only the steps described in “Creating and Deleting a Dynamic Aggregate Group” on
page 8-9 is necessary to configure a dynamic link aggregate group. However, if you need to modify any of
the parameters listed in the table on page 8-3, please see “Modifying Dynamic Link Aggregate Group
Parameters” on page 8-12 for more information.
Note. See the “Link Aggregation Commands” chapter in the OmniSwitch CLI Reference Guide for
complete documentation of show commands for link aggregation.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the OmniSwitch os6900 and is the answer not in the manual?

OmniSwitch os6900 Specifications

General IconGeneral
BrandOmniSwitch
Modelos6900
CategorySwitch
LanguageEnglish