EasyManuals Logo

OmniSwitch os6900 User Manual

Default Icon
942 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #843 background imageLoading...
Page #843 background image
Diagnosing Switch Problems Port Monitoring
OmniSwitch AOS Release 7 Network Configuration Guide June 2013 page 32-25
Configuring a Port Monitoring Session
To configure a port monitoring session, use the port-monitoring source command by entering port -
monitoring, followed by the user-specified session ID number, source, the slot number of the port to be
monitored, a slash (/), and the port number of the port.
For example, to configure port monitoring session 6 on port 2/3 enter:
-> port-monitoring 6 source 2/3
Note. One port monitoring session can be configured per chassis.
In addition, you can also specify optional parameters shown in the table below. These parameters must be
entered after the slot and port number.
For example, to configure port monitoring session 6 on port 2/3 and administratively enable it, enter:
-> port-monitoring 6 source 2/3 enable
These keywords can be used when creating the port monitoring session or afterwards. See the sections
below for more information on using these keywords.
Enabling a Port Monitoring Session
To disable a port monitoring session, use the port-monitoring source command by entering port -moni-
toring, followed by the user-specified session ID number, source, the slot number of the port to be moni-
tored, a slash (/), the port number of the port, and enable. For example, to enable port monitoring session
6 on port 2/3, enter:
-> port-monitoring 6 source 2/3 enable
Disabling a Port Monitoring Session
To disable a port monitoring session, use the port-monitoring command by entering port-monitoring,
followed by the port monitoring session ID and pause. For example, to disable port monitoring session 6,
enter:
-> port-monitoring 6 disable
Deleting a Port Monitoring Session
To delete a port monitoring session, use the no form of the port-monitoring command by entering no
port-monitoring, followed by the port monitoring session ID. For example, to delete port monitoring
session 6, enter:
-> no port-monitoring 6
keywords
file
no overwrite
bidirectional
disable
brief
no file
inport
timeout
capture-type
size
outport
enable
full

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the OmniSwitch os6900 and is the answer not in the manual?

OmniSwitch os6900 Specifications

General IconGeneral
BrandOmniSwitch
Modelos6900
CategorySwitch
LanguageEnglish