Configuring Dynamic Link Aggregation Modifying Dynamic Link Aggregate Group Parameters
OmniSwitch AOS Release 7 Network Configuration Guide June 2013 page 8-25
Restoring the Partner Port System Priority
To remove a user-configured system priority from a dynamic aggregate group partner port configuration
use the no form of the linkagg lacp agg partner system-priority command by entering lacp port, the
slot number, a slash (/), the port number, and partner admin-system-priority.
For example, to remove a user-configured system ID from dynamic aggregate partner port 3 in slot 4,
enter:
-> no linkagg lacp port 4/3 partner admin-system-priority
Modifying the Partner Port Administrative Status
By default, the administrative status of a dynamic aggregate group partner port is 0. The following subsec-
tions describe how to configure a user-specified value and how to restore the value to its default value
with the linkagg lacp port partner admin-port command.
Configuring the Partner Port Administrative Status
You can configure the administrative status of a dynamic aggregate group partner port by entering link-
agg lacp port, the slot number, a slash (/), the port number, partner admin-port, and the user-specified
partner port administrative status.
For example, to modify the administrative status of dynamic aggregate partner port 1 in slot 7 to 200 you
would enter:
-> linkagg lacp port 7/1 partner admin-port 200
For example, to modify the administrative status of dynamic aggregate
partner port 1 in slot 7 to 200, enter:
-> linkagg lacp port 7/1 partner admin-port 200
Restoring the Partner Port Administrative Status
To remove a user-configured administrative status from a dynamic aggregate group partner port
configuration use the no form of the linkagg lacp port partner admin-port command by entering no
linkagg lacp agg, the slot number, a slash (/), the port number, and partner admin-port.
For example, to remove a user-configured administrative status from dynamic aggregate partner port 1 in
slot 7 you would enter:
-> no linkagg lacp port 7/1 partner admin-port
Modifying the Partner Port Priority
The default partner port priority is 0. The following subsections describe how to configure a user-specified
value and how to restore the value to its default value with the linkagg lacp port partner admin port-
priority command.
Configuring the Partner Port Priority
To configure the partner port priority, enter lacp agg, the slot number, a slash (/), the port number, part-
ner admin-port priority, and the user-specified partner port priority.
For example, to modify the port priority of dynamic aggregate partner port 3 in slot 4 to 100 you would
enter:
-> linkagg lacp port 4/3 partner admin-port priority 100
To Next Page
Loading...
Need help?
General