Configuring Auto-Fabric Configuring Dynamic Automatic Fabric
page 14-14 OmniSwitch AOS Release 7 Network Configuration Guide June 2013
Configuring Auto-Fabric
This section describes commands to configure virtual chassis on an OmniSwitch.
• “Enabling/Disabling Auto-Fabric” on page 14-14
• “Starting the Discovery Process” on page 14-14
• “Configuring Auto-Fabric Protocols” on page 14-14
• “Configuring Discovery Interval” on page 14-14
• “Configuring and Saving the Discovered Configuration” on page 14-15
Enabling/Disabling Auto-Fabric
Auto-Fabric can enabled or disabled globally or per interface. To enable or disable auto-fabric globally or
on an interface use the auto-fabric admin-state command. For example:
-> auto-fabric admin-state enable
-> auto-fabric interface 1/1 admin-state enable
Starting the Discovery Process
The discovery can be manually started. To manually begin the discovery process use the auto-fabric
discovery start command. For example:
-> auto-fabric discovery start
Configuring Auto-Fabric Protocols
Each protocol can be enabled or disabled globally or per port. To enable or disable protocols use the auto-
fabric protocols command. For example:
-> auto-fabric protocols lacp admin-state disable
-> auto-fabric protocols mvrp admin-state enable
-> auto-fabric protocols spb interface 1/3 admin-state disable
Configuring Discovery Interval
Configurable for LACP and SPB. To configure the discovery timer, use the auto-fabric discovery-inter-
val command. For example:
-> auto-fabric discovery interval 60
For more information on Virtual Fabric Link, see “Creating the Virtual Fabric Link (VFL)” on page 9-20
in Chapter 9, “Configuring Virtual Chassis.”
To Next Page
Loading...
Need help?
General