OmniSwitch os6900 User Manual

Configuring RIP RIP Options
OmniSwitch AOS Release 7 Network Configuration Guide June 2013 page 19-11
Enabling a RIP Host Route
A host route differs from a network route, which is a route to a specific network. This command allows a
direct connection to the host without using the RIP table. If a switch is directly attached to a host on a
network, use the ip rip host-route command to enable a default route to the host. For example:
-> ip rip host-route
The default is to enable a default host route.
Use the no ip rip host-route command to disable the host route. Use the show ip rip command to display
the current host route status.

OmniSwitch os6900 Specifications

General

Brand	OmniSwitch
Model	os6900
Category	Switch
Language	English