Verifying the IP Configuration Configuring IP
page 15-36 OmniSwitch AOS Release 7 Network Configuration Guide June 2013
Verifying the IP Configuration
A summary of the show commands used for verifying the IP configuration is given here:
For more information about the displays that result from these commands, see the
OmniSwitch CLI Reference Guide.
show ip interface Displays the usability status of interfaces configured for IP.
show ip routes Displays the IP Forwarding table.
show ip route-pref Displays the configured route preference of a router.
show ip router database Displays a list of all routes (static and dynamic) that exist in the IP
router database.
show ip config Displays IP configuration parameters.
show ip protocols Displays switch routing protocol information and status.
show ip router-id Displays the status of TCP/UDP service ports. Includes service name
and well-known port number.
show arp Displays the ARP table.
show arp filter Displays the ARP filter configuration for the switch.
show icmp control This command allows the viewing of the ICMP control settings.
show ip dos config Displays the configuration parameters of the DoS scan for the switch.
show ip dos statistics Displays the statistics on detected port scans for the switch.
show ip dos arp-poison Displays the number of attacks detected for a restricted address.
To Next Page
Loading...
Need help?
General