Configuring Multi-chassis Link Aggregation Recommended Configuration Parameters
OmniSwitch AOS Release 7 Network Configuration Guide June 2013 page 10-33
Recommended Configuration Parameters
Multi-chassis peers in the same domain must maintain identical configuration and operational parameters.
Ensure that the mandatory parameters are the same on both peers. Multi-chassis functionality is optimal
with unified management on participating chassis. Any mismatch or mis-configuration can adversely
affect network traffic behavior. There is no automatic check or facility to check for mis-configuration.
Ensure that the following recommended parameters are configured identical on both the chassis.
• MAC Address Aging Timer
• MCLAG member ports: port speed and duplex
• Static MAC Entries
• QoS Configuration
• Port Security Configuration
• IGMP Snooping Configuration
• IP interface configuration
• Routing Protocols Configuration
• VRRP Configuration
Verifying Parameter Consistency
Parameter consistency is performed automatically at start time and relevant runtime when any configura-
tion changes are applied to either chassis. If there is any persistent mismatch of the mandatory parame-
ters, then the global operation state of the Multi-Chassis feature will be updated as operationally down.
Inconsistency between some of the non-mandatory MCLAG aggregate parameters prevents a particular
MCLAG or all MCLAG aggregates from becoming operational. The mandatory parameters for MCLAG
and the impact of their violation are: as follows:
To Next Page
Loading...
Need help?
General