Using Static MAC Addresses Managing Source Learning
page 3-4 OmniSwitch AOS Release 7 Network Configuration Guide June 2013
Configuring Static MAC Addresses
To configure a permanent, bridging static MAC address, see the example below:
-> mac-learning vlan 1 port 1/1 static mac-address 00:00:02:CE:10:37 bridging
Use the no form of this command to clear MAC address entries from the table. :
-> no mac-learning vlan 1 port 1/1 static mac-address 00:00:02:CE:10:37 bridging
To verify static MAC address configuration and other table entries, use the show mac-learning command.
For more information about this command, see the OmniSwitch CLI Reference Guide.
Static MAC Addresses on Link Aggregate Ports
Static MAC Addresses are not assigned to physical ports that belong to a link aggregate. Instead, they are
assigned to a link aggregate ID that represents a collection of physical ports. This ID is specified at the
time the link aggregate of ports is created.
To configure a static MAC address on a link aggregate ID 1 belong to VLAN 1 see the example below:
-> mac-learning vlan 1 linkagg 1 static mac-address 00:00:02:CE:10:37 bridging
For more information about configuring a link aggregate of ports, see Chapter 7, “Configuring Static Link
Aggregation” and Chapter 8, “Configuring Dynamic Link Aggregation.”
To Next Page
Loading...
Need help?
General