Name: OmniSwitch os6900
Brand: OmniSwitch
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Configuring MVRP Configuring MVRP

page 12-10 OmniSwitch AOS Release 7 Network Configuration Guide June 2013

Configuring MVRP Registration

MVRP allows a port to register and de-register static VLANs. Every device has a list of all the switches

and end stations that can be reached at any given time. When an attribute for a device is registered or

de-registered, the set of reachable switches and end stations, also called participants, is

modified. Data frames are propagated only to registered devices, thereby preventing attempts to send data

to devices that are not reachable.

The following sections describe MVRP registration on switches:

Setting MVRP Normal Registration

The normal registration mode allows dynamic creation, registration, and de-registration of VLANs on a

device. The normal mode is the default registration mode.

To configure a port in normal mode, use the mvrp registration command. For example, to configure port

2 of slot 1 in normal mode, enter the following:

-> mvrp port 1/2 registration normal

To view the registration mode of the port, use the show mvrp port command. For example:

-> show mvrp port 1/2

MVRP Enabled : no,

Registrar Mode : normal,

Applicant Mode : participant,

Join Timer (msec) : 600,

Leave Timer (msec) : 1800,

LeaveAll Timer (msec) : 30000,

Periodic Timer (sec) : 1,

Periodic Tx status : disabled

Setting MVRP Fixed Registration

The fixed registration mode allows only manual registration of the VLANs and prevents dynamic or static

de-registration of VLANs on the port.

To configure a port to fixed mode, use the mvrp registration command. For example, to configure port 2

of slot 1 to fixed mode, enter the following:

-> mvrp port 1/2 registration fixed

To view the registration mode of the port, use the show mvrp port command. For example,