Configuring VRF Instances Configuring Multiple VRF
page 16-18 OmniSwitch AOS Release 7 Network Configuration Guide June 2013
Configuring Routing Protocols for a Specific VRF Instance
There are no additional CLI commands or parameters required to associate a routing protocol configura-
tion (for example, RIP, BGP, OSPF) with a specific VRF instance. Instead, the VRF CLI context is used to
determine the association between a specific routing configuration and a VRF instance. For example, if a
BGP routing instance is configured when VRF instance IpOne is the active CLI context, then the BGP
routing instance is associated with IpOne. All traffic for the BGP instance is routed and forwarded on the
interfaces associated with VRF IpOne.
For more information about the interaction of switch applications with VRF instances, see “VRF Interac-
tion With Other Features” on page 16-11. To see examples of configuring routing protocol instances
within the context of a VRF instance, refer to “Quick Steps for Configuring Multiple VRF” on page 16-3.
Removing a VRF Instance
To remove a VRF instance from the switch configuration, use the no form of the vrf command.
For example:
-> no vrf IpTwo
To view a list of VRF instances configured on the switch, use the show vrf command. For more informa-
tion about this command, see the OmniSwitch CLI Reference Guide.
To Next Page
Loading...
Need help?
General