Using Condition Groups in Policies Configuring QoS
page 25-56 OmniSwitch AOS Release 7 Network Configuration Guide June 2013
A shortcut for this command replaces the protocol, source ip port, and destination ip port keywords
with source tcp port and destination tcp port:
-> policy service ftp2 source tcp port 20-21 destination tcp port 20
Multiple services created through the policy service command can be associated with a policy service
group; or, individual services can be configured for a policy condition. If you have multiple services to
associate with a condition, configure a service group and attach it to a condition. Service groups are
described in “Creating Service Groups” on page 25-56.
Note. Service configuration is not active until the qos apply command is entered.
To remove a policy service, enter the no form of the command.
-> no policy service ftp2
The ftp2 service is deleted from the configuration at the next qos apply if the service is not currently asso-
ciated with a policy condition or a service group.
Creating Service Groups
Service groups are made up of policy services. First configure the policy service, then create the service
group which includes the policy service(s).
Use the policy service group command. For example:
-> policy service group serv_group telnet1 ftp2
In this example, a policy service group called serv_group is created with two policy services (telnet1 and
ftp2). The policy services were created with the policy service command. (See “Creating Services” on
page 25-55 for information about configuring policy services.)
Note. The policy service group can include only services with all source ports, all destination ports, or all
source and destination ports. For example, the group cannot include a service that specifies a source port
and another service that specifies a destination port.
The service group can then be associated with a condition through the policy condition command. For
example:
-> policy condition c6 service group serv_group
This command configures a condition called c6 with service group serv_group. All of the services
specified in the service group are included in the condition. (For more information about configuring
conditions, see “Creating Policy Conditions” on page 25-45.)
Note. Service group configuration must be specifically applied to the configuration with the qos apply
command.
To delete a service from the service group, use no with the relevant service name. For example:
-> policy service group serv_group no telnet1
To Next Page
Loading...
Need help?
General