Configuring Global QoS Parameters Configuring QoS
page 25-42 OmniSwitch AOS Release 7 Network Configuration Guide June 2013
The log display can be modified through the qos log lines, qos log level, and debug qos commands. The
log display can also be output to the console through the qos log console command or sent to the policy
software in the switch (which manages policies downloaded from an LDAP server) through the qos
forward log command.
Clearing the QoS Log
The QoS log can get large if invalid rules are configured on the switch, or if a lot of QoS events have taken
place. Clearing the log makes the file easier to manage.
To clear the QoS log, use the clear qos log command. For example:
-> clear qos log
All the current lines in the QoS log are deleted.
Setting the Statistics Interval
To change how often the switch polls the network interfaces for QoS statistics, use the qos stats interval
command with the desired interval time in seconds. The default is 60 seconds. For example:
-> qos stats interval 30
Statistics are displayed through the show qos statistics command. For more information about this
command, see the OmniSwitch CLI Reference Guide.
Returning the Global Configuration to Defaults
To return the global QoS configuration to its default settings, use the qos reset command. The defaults
then become active on the switch. For a list of global defaults, see “QoS Defaults” on page 25-34.
Note. The qos reset command only affects the global configuration. It does not affect any policy
configuration.
Verifying Global Settings
To display information about the global configuration, use the following show commands:
For more information about the syntax and displays of these commands, see the OmniSwitch CLI Refer-
ence Guide.
show qos config Displays global information about the QoS configuration.
show qos statistics Displays statistics about QoS events.
To Next Page
Loading...
Need help?
General