OmniSwitch os6900 User Manual

Ethernet OAM Specifications Configuring Ethernet OAM
page 35-2 OmniSwitch AOS Release 7 Network Configuration Guide June 2013
Ethernet OAM Specifications
The following table lists Ethernet OAM specifications.
Ethernet OAM Defaults
The following table shows Ethernet OAM default values.
Standards Supported IEEE 802.1ag Version 8.1–Connectivity Fault
Management
IEEE 802.1D–Media Access Control (MAC) Bridges
IEEE 802.1Q–Virtual Bridged Local Area Networks
ITU-T Y.1731–OAM Functions and Mechanisms for
Ethernet-Based Networks
Platforms Supported OmniSwitch 10K, 6900
Maximum Maintenance Domains (MD)
per Bridge
8
Maximum Maintenance Associations
(MA) per Bridge
128
Maximum Maintenance End Points
(MEP) per Bridge
256
Maximum MEP CMM Database Size 1K
Parameter Description Command Default Value/Comments
MHF value assigned to a MD ethoam domain mhf none
ID-permission value for MD entry ethoam domain id-permission none
MHF value assigned to a MA ethoam association mhf defer
Continuity Check Message interval
for the MA
ethoam association ccm-
interval
10 seconds
Default domain level ethoam default-domain level 0
Default domain MHF value ethoam default-domain mhf none
Default domain ID permission ethoam default-domain id-
permission
none
The administrative status of the MEP ethoam endpoint admin-state disable
The priority value for CCMs and
LTMs transmitted by the MEP
ethoam endpoint priority 7
The lowest priority fault alarm for
the lowest priority defect for a MEP
ethoam endpoint lowest-
priority-defect
mac-rem-err-xcon
Number of Loopback messages ethoam loopback 1
Fault notification alarm time ethoam fault-alarm-time 250 centiseconds
Fault notification generation reset
time
ethoam fault-reset-time 1000 centiseconds

OmniSwitch os6900 Specifications

General

Brand	OmniSwitch
Model	os6900
Category	Switch
Language	English