Using Static Multicast MAC Addresses Managing Source Learning
page 3-6 OmniSwitch AOS Release 7 Network Configuration Guide June 2013
If a a MAC address, slot/port and VLAN ID are not specified with this form of the command, then all
static multicast addresses are deleted. For example, the following command deletes all static MAC
addresses, regardless of their slot/port or VLAN assignments:
-> no mac-learning multicast
To verify the static MAC address configuration and other table entries, use the show mac-learning and
show mac-learning commands. For more information about these commands, see the OmniSwitch CLI
Reference Guide.
Static Multicast MAC Addresses on Link Aggregate Ports
Static multicast MAC addresses are not assigned to physical ports that belong to a link aggregate. Instead,
they are assigned to a link aggregate ID that represents a collection of physical ports. This ID is specified
at the time the link aggregate of ports is created and when using the mac-address-table static-multicast
command.
To configure a static multicast MAC address on a link aggregate ID, use the mac-learning multicast
mac-address command with the linkagg keyword to specify the link aggregate ID. For example, the
following command assigns a static multicast MAC address to link aggregate ID 2 associated with VLAN
455:
-> mac-learning vlan 455 linkagg 2 multicast mac-address 01:95:2A:00:3E:4c
To Next Page
Loading...
Need help?
General