Modifying IPMS Parameters Configuring IP Multicast Switching
page 24-16 OmniSwitch AOS Release 7 Network Configuration Guide June 2013
Restoring the IGMP Query Response Interval
To restore the IGMP query response interval to its default value on the system if no VLAN is specified,
use the ip multicast query-response-interval command by entering:
-> ip multicast query-response-interval 0
Or, as an alternative, enter:
-> ip multicast query-response-interval
To restore the IGMP query response interval to its default value.
You can also restore the IGMP query response interval on the specified VLAN by entering:
-> ip multicast van 2 query-response-interval 0
Or, as an alternative, enter:
-> ip multicast vlan 2 query-response-interval
To restore the IGMP query response interval to its default value.
Modifying the IGMP Router Timeout
The default IGMP router timeout (i.e., expiry time of IP multicast routers) is 90 seconds. The following
subsections describe how to configure a user-specified router timeout value and how to restore it with the
ip multicast router-timeout command.
Configuring the IGMP Router Timeout
You can modify the IGMP router timeout from 1 to 65535 seconds by entering
ip multicast router-timeout followed by the new value. For example, to set the IGMP router timeout to
360 seconds on the system if no VLAN is specified, you would enter:
-> ip multicast router-timeout 360
You can also modify the IGMP router timeout on the specified VLAN by entering:
-> ip multicast vlan 2 router-timeout 360
Restoring the IGMP Router Timeout
To restore the IGMP router timeout to its default value on the system if no VLAN is specified, use the ip
multicast router-timeout command by entering:
-> ip multicast router-timeout 0
Or, as an alternative, enter:
-> ip multicast router-timeout
To restore the IGMP router timeout to its default value.
To Next Page
Loading...
Need help?
General