Verifying the Ethernet OAM Configuration Configuring Ethernet OAM
page 35-14 OmniSwitch AOS Release 7 Network Configuration Guide June 2013
Verifying the Ethernet OAM Configuration
To display information about Ethernet OAM on the switch, use the show commands listed below:
show ethoam Displays the information of all the Management Domains configured on
the switch.
show ethoam domain Displays the information of a specific Management Domain configured
on the switch.
show ethoam domain
association
Displays the information of a specific MA in a Management Domain
configured on the switch.
show ethoam domain
association end-point
Displays the information of a specific MEP in a Management Domain
configured on the switch.
show ethoam remote-endpoint
domain
Displays the information of all remote MEPs learned as a part of the
CCM message exchange.
show ethoam default-domain
configuration
Displays all the default MD information for all the VLANs or a specific
VLAN.
show ethoam default-domain
configuration
Displays the values of scalar Default-MD objects
show ethoam vlan Displays the vlan association for a specified VLAN-ID
show ethoam cfmstack Displays the contents of CFM Stack Managed Object, which determines
the relationships among MEPs and MIPs on a specific switch port.
show ethoam linktrace-reply Displays the content of the Linktrace reply (LTR) returned by a previ-
ously transmitted LTM. This command displays the LTR based on the
transaction identifier or sequence number of the LTM for which the
LTR is to be displayed
show ethoam linktrace-tran-id Displays the transaction identifiers returned by previously generated
LTMs from a specified MEP.
show ethoam statistics Displays the Ethernet OAM statistics of all the Management Domains
configured on the switch. Also, displays the statistics of all the MAs and
matching MEPs for all the MDs.
show ethoam config-error Displays the configuration error for a specified VLAN, port or linkagg.
To Next Page
Loading...
Need help?
General