Configuring UDLD Configuring UDLD
page 2-6 OmniSwitch AOS Release 7 Network Configuration Guide June 2013
Configuring UDLD
This section describes how to use Command Line Interface (CLI) commands to do the following:
• “Enabling and Disabling UDLD” on page 2-6.
• “Configuring the Operational Mode” on page 2-7.
• “Configuring the Probe-Timer” on page 2-7.
• “Configuring the Echo-Wait-Timer” on page 2-7.
• “Clearing UDLD Statistics” on page 2-8.
• “Verifying the UDLD Configuration” on page 2-8.
Note. See the “UDLD Commands” chapter in the OmniSwitch CLI Reference Guide for complete
documentation of UDLD CLI commands.
Enabling and Disabling UDLD
By default, UDLD is disabled on all switch ports. To enable UDLD on a switch, use the udld command.
For example, the following command enables UDLD on a switch:
-> udld enable
To disable UDLD on a switch, use the udld command with the disable parameter. For example, the
following command disables UDLD on a switch:
-> udld disable
Enabling UDLD on a Port
By default, UDLD is disabled on all switch ports. To enable UDLD on a port, use the udld port
command. For example, the following command enables UDLD on port 3 of slot 1:
-> udld port 1/3 enable
To enable UDLD on multiple ports, specify a range of ports. For example:
-> udld port 1/6-10 enable
To disable UDLD on a port, use the udld port command with the disable parameter. For example, the
following command disables UDLD on a range of ports:
-> udld port 5/21-24 disable
To Next Page
Loading...
Need help?
General