OmniSwitch os6900 User Manual

Configuring IPsec on the OmniSwitch Configuring IPsec
page 18-14 OmniSwitch AOS Release 7 Network Configuration Guide June 2013
-> show ipsec policy tcp_in
Name = tcp_in
Priority = 500
Source = 3ffe:1:1:1::99
Destination = 3ffe:1:1:1::1
Protocol = TCP
Direction = in
Action = ipsec
State = active
Rules:
1 : esp
Description:
IPsec on all inbound TCP
Configuring an IPsec Rule
To configure an IPsec rule for a configured IPsec security policy, use the ipsec policy rule command
along with the policy name, index value for the IPsec policy rule, and IPsec protocol type (AH or ESP).
For example:
-> ipsec policy tcp_in rule 1 esp
The above command applies the configured IPsec security policy with rule 1 to ESP. The index value
specified determines the order in which a rule should get applied to the payload. The policy name config-
ured for the IPsec policy rule should be the same as the policy name configured for the IPsec security
policy. It’s possible to first encrypt the original content of an IPv6 packet using ESP and then authenticate
the packet using AH by configuring an ESP rule with an index of one and then configuring the AH rule
with an index of two. For example:
-> ipsec policy tcp_in rule 1 esp
-> ipsec policy tcp_in rule 2 ah
Use the no form of this command to remove the configured IPsec rule for an IPsec security policy. For
example:
-> no ipsec policy tcp_in rule 2
Verifying IPsec rule for IPsec Policy
To verify the IPsec policy, use the show ipsec policy command. For example:
-> show ipsec policy tcp_in
Name = tcp_in
Priority = 500
Source = 3ffe:1:1:1::99
Destination = 3ffe:1:1:1::1
Protocol = TCP
Direction = in
Action = ipsec
State = active
Rules:
1 : esp,
2 : ah
Description:
IPsec on all inbound TCP

OmniSwitch os6900 Specifications

General

Brand	OmniSwitch
Model	os6900
Category	Switch
Language	English