Configuring 802.1AB Configuring 802.1AB
OmniSwitch AOS Release 7 Network Configuration Guide June 2013 page 13-9
To disable 802.3 TLV on port 5 of slot 3, enter the following command at the CLI prompt:
-> lldp port 3/5 tlv dot3 mac-phy disable
Enabling and Disabling MED TLV
The lldp tlv med command is used to control per port LLDP Media End Device (MED) TLVs
transmission in the LLDPDUs on a specific port, a slot, or all ports on a switch. When enabled, the
LLDPDU administrative status must be in the transmit state.
To enable the LLDP-MED TLV LLDPDU transmission on a switch, enter the lldp tlv med command, as
shown:
-> lldp chassis tlv med power enable
To enable the MED TLV on port 4 of slot 4, enter the following command at the CLI prompt:
-> lldp port 4/4 tlv med capability enable
To disable the MED TLV on a switch, enter the lldp tlv med command, as shown:
-> lldp chassis tlv med power disable
To disable MED TLV on port 3 of slot 4, enter the following command at the CLI prompt:
-> lldp port 4/3 tlv med capability disable
Enabling and Disabling Application Priority TLV
The lldp tlv application command is used to include the LLDP-DCBx Application Priority TLV in the
LLDPDUs transmitted on a specific port, a slot, or all ports on a switch. When enabled, the LLDPDU
administrative status must be in the transmit state.
To enable the Application Priority TLV LLDPDU transmission on a switch, enter the lldp tlv application
command, as shown:
-> lldp chassis tlv application enable
To enable the Application Priority TLV on port 4 of slot 4, enter the following command at the CLI
prompt:
-> lldp port 4/4 tlv application enable
To disable the Application Priority TLV on a switch, enter the lldp tlv application command, as shown:
-> lldp chassis tlv application disable
To disable the Application Priority TLV on port 3 of slot 4, enter the following command at the CLI
prompt:
-> lldp port 4/3 tlv application disable
Configuring Application Priority TLV Parameters
The lldp tlv application priority command is used to configure the the LLDP-DCBx Application Prior-
ity TLV to advertise an 802.1p priority value for specific protocols on a specific port, a slot, or all ports on
a switch. The LLDPDU administrative status must be enabled and set to transmit and receive before using
To Next Page
Loading...
Need help?
General