Modifying Dynamic Link Aggregate Group Parameters Configuring Dynamic Link Aggregation
page 8-22 OmniSwitch AOS Release 7 Network Configuration Guide June 2013
Note. Specifying none removes all administrative states from the LACPDU configuration. For example:
-> linkagg lacp port 7/49 partner admin-state none
For example, to set bits 0 (active) and 2 (aggregate) on dynamic aggregate partner port 49 in slot 7, enter:
-> linkagg lacp port 7/49 partner admin-state active aggregate
For example, to set bits 0 (active) and 2 (aggregate) on dynamic aggregate partner port 49 in slot 7 and
document that the port is a Gigabit Ethernet port, enter:
-> linkagg lacp port 7/49 partner admin-state active aggregate
Restoring Partner Port System Administrative State Values
To restore LACPDU bit settings to their default values use the no form of the linkagg lacp agg partner
admin-state command and enter the active, timeout, aggregate, or synchronize keywords.
For example, to restore bits 0 (active) and 2 (aggregate) to their default settings on dynamic aggregate
partner port 1 in slot 7, enter:
-> no linkagg lacp port 7/1 partner admin-state active aggregate
collect Specifying this keyword has no effect because the system always
determines its value. When this bit (bit 4) is set by the system,
incoming LACPDU frames are collected from the individual ports that
make up the dynamic aggregate group.
distribute Specifying this keyword has no effect because the system always deter-
mines its value. When this bit (bit 5) is set by the system, distributing
outgoing frames on the port is disabled.
default Specifying this keyword has no effect because the system always deter-
mines its value. When this bit (bit 6) is set by the system, it indicates
that the partner is using defaulted actor information administratively
configured for the partner.
expire Specifying this keyword has no effect because the system always deter-
mines its value. When this bit (bit 7) is set by the system, the actor can-
not receive LACPDU frames.
Keyword Definition
To Next Page
Loading...
Need help?
General