Configuring Dynamic Link Aggregation Displaying Dynamic Link Aggregation Configuration and Statistics
OmniSwitch AOS Release 7 Network Configuration Guide June 2013 page 8-31
For example, to display detailed statistics for port 1 in slot 2 that is attached to dynamic link aggregate
group 1, enter:
-> show linkagg port 2/1
A screen similar to the following would be displayed:
Dynamic Aggregable Port
SNMP Id : 2001,
Slot/Port : 2/1,
Administrative State : ENABLED,
Operational State : DOWN,
Port State : CONFIGURED,
Link State : DOWN,
Selected Agg Number : NONE,
Primary port : UNKNOWN,
LACP
Actor System Priority : 10,
Actor System Id : [00:d0:95:6a:78:3a],
Actor Admin Key : 8,
Actor Oper Key : 8,
Partner Admin System Priority : 20,
Partner Oper System Priority : 20,
Partner Admin System Id : [00:00:00:00:00:00],
Partner Oper System Id : [00:00:00:00:00:00],
Partner Admin Key : 8,
Partner Oper Key : 0,
Attached Agg Id : 0,
Actor Port : 7,
Actor Port Priority : 15,
Partner Admin Port : 0,
Partner Oper Port : 0,
Partner Admin Port Priority : 0,
Partner Oper Port Priority : 0,
Actor Admin State : act1.tim1.agg1.syn0.col0.dis0.def1.exp0,
Actor Oper State : act1.tim1.agg1.syn0.col0.dis0.def1.exp0,
Partner Admin State : act0.tim0.agg1.syn1.col1.dis1.def1.exp0,
Partner Oper State : act0.tim0.agg1.syn0.col1.dis1.def1.exp0
Note.
When the multi-chassis link aggregation feature is activated on the switch, the show linkagg port
command displays the output as MC-Dynamic Aggregable Port.
See the “Link Aggregation Commands” chapter in the OmniSwitch CLI Reference Guide for complete
documentation of show commands for link aggregation.
To Next Page
Loading...
Need help?
General