Quick Steps for Configuring Auto-Fabric Configuring Dynamic Automatic Fabric
page 14-6 OmniSwitch AOS Release 7 Network Configuration Guide June 2013
Viewing the Auto-Fabric Configuration
1 Use the show auto-fabric config command to check the global configuration.
-> show auto-fabric config
Global Auto-Fabric Status : Enable,
Global Auto-Fabric Discovery Status : Idle,
Global Auto-Fabric Discovery Interval : 1 minute,
Global Auto-Fabric LACP Discovery Status : Enabled,
Global Auto-Fabric SPB Discovery Status : Enabled,
Global Auto-Fabric MVRP Discovery Status : Enabled,
Auto-Fabric Config Save Timer Status : Disabled,
Global Auto-Fabric Config Save Timer Interval : 300 seconds
2 Use the show auto-fabric config interface command to check the interface configuration.
-> show auto-fabric config interface 1/3
Auto-Fabric Interface Config:
Port 1/3 :
Auto-Fabric Status : Pending
Admin-Status
Global : Enabled, Port : Enabled
LACP
Global : Enabled, Port : Enabled
SPB-M
Global : Enabled, Port : Enabled
MVRP
Global : Enabled, Port : Enabled