OmniSwitch AOS Release 7 Network Configuration Guide June 2013 page 1-1
1 Configuring Ethernet Ports
The Ethernet software is responsible for a variety of functions that support Ethernet, Gigabit Ethernet, and
10 Gigabit Ethernet ports on OmniSwitch Series switches. These functions include
diagnostics, software loading, initialization, configuration of line parameters, gathering statistics, and
responding to administrative requests from SNMP or CLI.
In This Chapter
This chapter describes the Ethernet port parameters of the switch and how to configure them through the
Command Line Interface (CLI). CLI Commands are used in the configuration examples.
Configuration procedures described in this chapter include:
• “Ethernet Ports Overview” on page 1-4
• “Configuring Ethernet Port Parameters” on page 1-4
• “Clearing Ethernet Port Violations” on page 1-11
• “Link Monitoring” on page 1-12
• “Link Fault Propagation” on page 1-16
For information about CLI commands that can be used to view Ethernet port parameters, see the
OmniSwitch CLI Reference Guide.
To Next Page
Loading...
Need help?
General