Configuring IPv6 Configuring Route Map Redistribution
OmniSwitch AOS Release 7 Network Configuration Guide June 2013 page 17-25
Configuring Route Map Redistribution
The ipv6 redist command is used to configure the redistribution of routes from a source protocol into the
destination protocol. This command is used on the IPv6 router that will perform the redistribution.
Note. A router automatically becomes an Autonomous System Border Router (ASBR) when redistribu-
tion is configured on the router.
A source protocol is a protocol from which the routes are learned. A destination protocol is the one into
which the routes are redistributed. Make sure that both protocols are loaded and enabled before configur-
ing redistribution.
Redistribution applies criteria specified in a route map to routes received from the source protocol. There-
fore, configuring redistribution requires an existing route map. For example, the following command
configures the redistribution of OSPFv3 routes into the RIPng network using the ospf-to-rip route map:
-> ipv6 redist ospf into rip route-map ospf-to-rip
OSPFv3 routes received by the router interface are processed based on the contents of the ospf-to-rip route
map. Routes that match criteria specified in this route map are either allowed or denied redistribution into
the RIPng network. The route map may also specify the modification of route information before the route
is redistributed. See “Using Route Maps” on page 17-21 for more information.
To remove a route map redistribution configuration, use the no form of the ipv6 redist command. For
example:
-> no ipv6 redist ospf into rip route-map ospf-to-rip
Use the show ipv6 redist command to verify the redistribution configuration:
-> show ipv6 redist
Source Destination
Protocol Protocol Status Route Map
------------+------------+---------+--------------------
localIPv6 RIPng Enabled ipv6rm
OSPFv3 RIPng Enabled ospf-to-rip
Configuring the Administrative Status of the Route Map Redistribution
The administrative status of a route map redistribution configuration is enabled by default. To change the
administrative status, use the admin-state parameter with the ipv6 redist command. For example, the
following command disables the redistribution administrative status for the specified route map:
-> ipv6 redist ospf into rip route-map ospf-to-rip admin-state disable
The following command example enables the administrative status:
-> ipv6 redist ospf into rip route-map ospf-to-rip admin-state enable
To Next Page
Loading...
Need help?
General